Wait for 5 more seconds, the motor emits a special tone 56712, that means the controller enters the programming mode.
The controller can be reoperated at the halved power after the throttle returns to zero.
Discount Marine Parts has a large inventory of parts for most brands of American made Outboards, Inboards and Sterndrives.Program card is an optional equipment for boat ESCs, it has 3 digital LEDs to display the programmable items and corresponding parameter values, so the user interface is very intuitive.Move the throttle stick to the bottom position full brake then turn on the transmitter.Note: if the transmitter has the ABS brake function, please disable.We strongly recommend activating the Fail Save function of the radio system and set it (F/S) to Output OFF or set its value to the Neutral Position to ensure the boat can be stopped when there is no signal received from the transmitter.
If you choose the Auto Calculate, the ESC will measure the battery voltage the moment it is connected to the controller, then the ESC counts the cells number.
Connect main battery pack to the ESC.
If only one Beep tone is emitted, that means the Low-voltage Cutoff Threshold (Please refer to the Programmable Items daken model bt10000 instruction manual in the following form) is set to No protection, and its only suitable when you are maya 2008 crack xp using a NiMH/NiCd battery pack.Possible causes: The ESC and motor wire are not well connected or the ESC / motor is damaged Solution(s Check all the connections; replace the ESC or the motor.Choose a new value for the selected item After entered a certain item, the motor will beep in a loop.Sea King quality parts and accessories are offered at far less cost than other major outboard brands, cheat code gta 5 playstation 2 including Yamaha, Mercury, Suzuki, Johnson Evinrude, Tohatsu and Nautic outboards.There are two LED indicators in the ESC, a Green one and a Red one.Connect the program box with the ESC through the programming wire (shorter wire).
Disconnect the battery pack from the ESC to exit the programming mode forcibly.
Possible causes: The Low-Voltage Cutoff Protection or the Overheat Protection is activated.
Motors were manufactured by various manufactures over the years.