logo
Main Page Sitemap

Mighty mule 500 troubleshooting manual


An extra open or close command is able to get door to complete cycle.
4) Brake is not functioning properly Make sure that the brake operates correctly.
2) Enabling Switch not turned.
If the sensor indicator lights do not light, replace the safety sensors LED is not lit on door control Inspect door control/wires for crack wep key os x a short (staple in crack serial artlantis 4 wire replace as needed.
Radio controls will not close the gate from the open limit 1) Radio terminals R1-4 are factory configured for commercial radio function Configure terminals R1-4 for residential radio for residential radio function by performing the following modifications:.Check travel module for proper assembly, replace if necessary.The range includes single 1/2 HP motor models, dual 1/2 HP motor models, as well as 1 HP motor models.Also includes core nursing questions that you learned in school.Make sure that the gate runs smoothly and does not bind.The door will open but will only close after a five second delay with constant pressure on the close button a) The photoelectric sensors, edge or other sensing device is obstructed or activated If the on board lmep LED is flashing, the photoelectric sensor are.Retest that obstructing photoelectric sensor causes moving gate to stop, and may reverse direction.Green LED next to stop button must.There is a command holding the gate open.



Door reverses for no apparent reason and opener light flashes 10 times: Check The Protector System (if you have installed this accessory).
If operator is in a dual gate configuration, make sure that the communication wiring between the two units is undamaged and complete.
Chamberlain GH garage door opener troubleshooting.Remove any obstruction or align the receiving eye.Adjust settings as needed c) Defective vehide loop detector or loop wire c) Check Shadow loop wire.Over-voltage at the 120Vac line input.If the soft open or interrupt (safety) loop LED.Re-Tighten the outer nut until the trolley spring is approximately 1-1/4" (3.18 cm) in length.Symptom: Sending indicator light glows steadily, receiving indicator light is dim or flashing.Photoelectric sensor does not stop or reverse gate.A) Incorrect photoelectric sensor wiring a) Check photoelectric sensor wiring.If the contactor stops chattering, find an alternate pov/er source for some of the devices.Set Timer to Close.





The default UDP timer should be changed, which will change the UDP connection timer for any new rule made to the Sonicwall.
If motor unit activates, replace control console wires.
MyQ devices communicate using a 900 MHz radio signal.

Sitemap